The T6-DDI Video Adapter Card provides connector access to COM Express® Type 6 module Digital Display Interface (DDI) outputs. The T6-DDI adapter provides three output channels that can be set to either HDMI or DisplayPort independently and includes a passive DisplayPort to DVI dongle.
The P16TO28 adapter card allows you to run two PCIe x8 add-on cards from a single PCIe x16 slot. The card plugs into a standard PCIe x16 slot and splits the signals into two separate x8 connectors (front and rear).
The COM-T6T2 adapter board allows COM Express Type 6 modules to be backwards compatible with Type 2 carrier boards. An onboard SATA-to-PATA converter and PCIe-to-PCI bridge provide signal conversion for the required COM Express Type 2 interfaces. The SDVO port is rerouted to correspond to the Type 2 pin definition (PCIe x16 is not supported).
The Flat Panel Transfer Board (FPTB) allows prototyping and verification of TTL flat panel displays with COM Express modules that support LVDS output only. The FPTB includes an LVDS-to-TTL converter, onboard PWM circuitry to support backlight control for LVDS and TTL displays, and has a EDID EEPROM to enable plug and play flat panel support.
The FI-CH7307 is an ADD2 DVI Card that fits into a standard PCIe x16 slot and converts SDVO signals to DVI display output.
The LPC_DEBUG_2 is an LPC POST debug board equipped with POST Status LEDs. It can be easily connected to the LPC debug port on all ADLINK Computer-on-Modules to monitor BIOS POST status.