MNET-DA2 / MNET-SAN - Motion Control - Motionnet - ADLINK Technology
ADLINK Home > Products > Motion Control > Motionnet > MNET-DA2 / MNET-SAN
ADLINK-MNET-DA2 / MNET-SAN-Motion Control-Motionnet
[+] Enlarge Picture


Contact Us
 Email Us
 Worldwide Offices
 Where to Buy

Get a Quote

MNET-DA2 / MNET-SAN

 Get a Quote  Datasheet
Distributed Single-axis Motion Control Modules for Delta and Sanyo

Features
  • No command frequency limitation
  • Available for Delta A2, and Sanyo R series
  • Up to 64 axes, serially connected
  • No need for terminal boards-reduces space
  • The scanning cycle time up to 0.97 ms at 20 Mbps when 64 axes are connected
  • Point-to-point application can be easily completed with multiple single-axis modules
  • Support linear/s-curve acceleration and deceleration
      |  Datasheet |      

  Introduction  
  Ordering Information  
ADLINK¡¦s Motionnet products provide system integrators with a simple configuration and reduced wiring method for a cost-effective solution for motion applications utilizing multiple single axis. With this new concept of direct plug-in modules, the amount of space used and the amount of wiring required is greatly reduced from traditional terminal board connections. After the module is plugged into the servo driver, all that is needed is a LAN cable to make the serial connection between the modules. Different servo drivers can be lined up on the Motionnet bus, making motion control configuration much simpler than PCI board solutions. The Motionnet bus can support up to 64 single-axis modules.


Get a Quote


ADLINK Facebook ADLINK Google Plus ADLINK Twitter ADLINK Linkedin    Contact Us | Career | Investor Relations | Partner Center | Sitemap |
Copyright © ADLINK Technology Inc., Specification and product names are trademarks or trade names of their respective companies or organizations.