LEC-BASE R1 - Computer-on-Modules - SMARC-LEC-Carrier-Board - ADLINK Technology
ADLINK Home > Products > Computer-on-Modules > SMARC-LEC-Carrier-Board > LEC-BASE R1
ADLINK-LEC-BASE R1-Computer-on-Modules-SMARC-LEC-Carrier-Board
[+] Enlarge Picture


Contact Us
 Email Us
 Worldwide Offices
 Where to Buy

Get a Quote

LEC-BASE R1

 Get a Quote  Datasheet
SMARC compliant reference carrier board for all LEC modules.

Features
  • SMARC compliant carrier board with MXM3 connector
  • Compatible with both short and full size SMARC modules
  • Supports parallel RGB, LVDS and HDMI displays
  • Two mini PCIe slots for expansion cards (e.g. WiFi, 3G)
  • 2 camera connectors
  • 4x UART, 2x CAN
  • USB hub
      |  Datasheet |  Quick Start Guide | Other Document |     

  About SMARC  
  Ordering Information  
SMARC® vs COM Express®

COM Express® is a very successful computer-on-module (COM) standard that is optimized for PC architecture based embedded systems. The COM Express feature set exploits contemporary PC chipsets very well. There is support for numerous USB ports and PCI Express lanes, PCI Express graphics, LPC bus and PCI bus, as well as power pins supporting over 100 watts.

The SMARC specification targets lower power, small form factor systems. The SMARC pin out is optimized for features common to ARM CPUs rather than those of the PC architecture. Some of these features include parallel LCD display interfaces; provisions for serial and parallel camera input; multiple I2C, I2S, SPI and serial port options; USB client/host mode and OTG (on the go) operation and SD/eMMC card operation. The SMARC specification also includes some of the features found in COM Express, such as a limited number of PCIe, SATA and USB ports, but provides a combination of interfaces that allows many features of interest not supported by COM Express to be made available for contemporary mobile applications.

Two module sizes - 82mm x 50mm - 82mm x 80mm

Carrier board connector: 314 pin MXM pin-out - Low cost - Low profile - Excellent signal integrity - Robust, vibration resistant connector

Module input voltage range: 3.0V to 5.25V - Allows operation using 3.6V nominal Lithium-ion battery packs - Allows operation using 3.3V fixed DC supply - Allows operation using 5.0V fixed DC supply - Single power supply (no separate standby voltage) - Module power pins allow 5A max, or 15W max input power at 3.0V

Low power designs - 1W to 6W typical module power draw during active operation - Fanless - Passive cooling - Lowest standby power - Designed for battery operation - 1.8V default I/O voltage


Get a Quote


ADLINK Facebook ADLINK Google Plus ADLINK Twitter ADLINK Linkedin    Contact Us | Career | Investor Relations | Partner Center | Sitemap |
Copyright © ADLINK Technology Inc., Specification and product names are trademarks or trade names of their respective companies or organizations.